Filter-holder made of stainless steel to use with solvents and chemical products. The surface of the top part is wrapped with PTFE, this material guarantees the stands without necessity of gasket, for this reason the resistance to warm its higher. The chemical compatibility depends on the introduced filter. The filtration can be done in both senses.
Connectors
Inlet Female luer lock
Outlet Male luer slip
Flow rate with water (ml/min /cm2 )p= 1 bar | 100 Kpa aprox.:
0.22 µm membrane 45 ml/min aprox.
0.45 µm membrane 80 ml/min aprox.
Chemical compatibility: the same than the stainless steel and PTFE.
Materials: stainless steel (1.4305) pieces superior and inferior. PTFE in the wrapping zone in the superior piece. Luran 368R in the pressure zone of the pieces.
Diameter: 25 mm
Filtration area: 3 cm²
Maximum pressure: 7 bar (700 kPa, 101,57 psi)
Membrane filter dimensions: 25 mm diameter
Hold-up volume < 0.1 ml before reaching the point of bubble , 0.3 ml before.
Sterilization: Autoclaving (max. 134ºC) or dry heat (max. 180ºC).
